View Single Post
  #1  
Old 08-29-2015, 07:37 AM
specious_reasons's Avatar
specious_reasons specious_reasons is offline
here to bore you with pictures
 
Join Date: May 2009
Posts: MMDIX
Default 3D printing failures

Already posted this on Facebook, but I like to share....

So, I've been having a bit of trouble with the Cobalt Blue filament I ordered. I was printing out a bunch of stuff and not getting good results.

So, I started printing small cubes, for calibration, and the tops of the cubes are really sucking. I thought they might be interesting under the microscope, so...

These 2 are the messed up tops of the cube.





This is the side of the cube.



These 2 are the shape of constant width, and some printing issues I'm having.



__________________
ta-
DAVE!!!
Reply With Quote
Thanks, from:
Ari (08-30-2015), BrotherMan (08-29-2015), Corona688 (03-08-2018), curses (08-31-2015), Dingfod (08-30-2015), Janet (08-29-2015), JoeP (08-30-2015), Kyuss Apollo (08-29-2015), LadyShea (08-30-2015), lisarea (08-29-2015), slimshady2357 (08-29-2015), Sock Puppet (08-31-2015), Stormlight (08-31-2015)
 
Page generated in 0.31248 seconds with 11 queries